Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

Abs sensor removal

thorpe991

By thorpe991,
in General Forums

 Share

Recommended Posts

thorpe991 NPORA Old-Timer

thorpe991

Posted
Posted

So my abs sensor went on the left side so I went to the jy to get a used one but can't get it off I took the bolt out but can't get it(abs sensor) to come out of the hub what am I doing wrong?

 

 

Sent from my iPod touch using Tapatalk

Link to comment
Share on other sites
Rebelord NPORA Old-Timer

Rebelord

Posted
Posted

The ABS sensor housing is steel, in a cast spindle. Combine that with time and it gets pretty seized up in there. When I had to remove mine, it was a PITA. Took me a few hours just to get it out. Then to get the new on in, was a PITA also.

Best bet is getting a new one. Because you'll probably destroy a JY one trying to get it out.

Link to comment
Share on other sites
Rebelord NPORA Old-Timer

Rebelord

Posted
Posted

Soak it with PB Blaster/Liquid Wrench etc real good.

Then with the old one, grab it tight with some vice grips and try to turn it back n forth to work out. Thats all I was able to do. Took me a few hours to get my old one out.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...