Jump to content

Remote start system


dakotab93
 Share

Recommended Posts

I have. I have a 1998 Manual 4x4

how hard was it to do, and by chance do you know exactly what wires you had to tie into, i have a 1997 4x4 so it should be the same.

Link to comment
Share on other sites

if you have any 12v wiring experience at all, its not too difficult. 99% of the wires are under the driver side dash at the ignition harness, and at the secu (security control unit) to the left of the steering column. Tach signal is underhood as well as hoodpin.

Link to comment
Share on other sites

I have some experience in it. I figured there was only 4 or five ignition wire that are need, do you know if its possible to tap into the harness behind the cluster for the tac? Any possible way you could post a picture?

Link to comment
Share on other sites

http://www.the12volt.com/installbay/alarmdetail/1640.html

That will give you pretty much everything you need. I tied into the tach from the gauge cluster. Only have two wires going into the engine bay. Hood pin and alarm siren. Not pictures. Don't feel like tearing it all apart.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...