Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

Bucking Bronco


Black93inMA
 Share

Recommended Posts

I recently posted this on the NEwbie Forum, but realize I'm not a newbie anymore, soooooooo here goes nuttin

 

OK so here is the latest news.....

I cut out the rust in the left rear wheel well frame area and welded in a new section with 1/8 plates.

I installed 4 new shocks on all corners as tubes were rusted on originals.

I replaced all the fluids and filters with proper weights and Lucas products.

 

After driving 100 miles or so I developed a surging problem where i would accelerate and at about 3000 RPM the engine would cut out down to 1000 RPM and then surge between 1000 and 2000 RPM's.

 

 

I then changed the fuel filter and the distributor cap+rotor. I noticed the distributor was missing the tab closest to the engine so only 2 screws hold on th cap not 3...

 

 

I drove it for a day (75 miles) and it seemed to have new life and more power in it and then all hell broke loose.

 

 

While accelerating onto highway traffic i hit 3500 RPM and the engine immediately dropped down to 1000 and began to surge, I feathered the pedal to try and gain speed as a semi beared down on me. The POWER light flickered on the dash and a red light on the dash came on near the check engine light.

I was able to get off at the next exit and drove back roads all the way home at under 3000 RPM.

I tried a little experiment on the way home.....I turned on the POWER button and accelerated quickly. This time the engine surged between 500 and 1500 bucking wildly, I let off the gas and it settle down.

 

Research on the forums gave me 'some' advice.... MAF? Fuel Pump? Ignition Coil? all three?

I think maybe I know why I paid $650 for this rig.....

 

Any advice would be great!

Link to comment
Share on other sites

Not sure about pathys but my driving instructing cars would sometimes go into "safe mode" cus of the kids. Had to disconnect then reconnect the battery to take it out. might be worth a shot.

thanks for the advice.........will try that!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...