Baker95pathy
-
Posts
23 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Posts posted by Baker95pathy
-
-
Yes overdrive is working. It shifts through every gear fine .
-
I think I have a bent valve or more than 1. I'm ganna check compression to be sure but probably ganna get knew heads. But should I rebuild the ones I have or get new or get some off of a wrecked junker.
-
I think I have a bent valve or more than 1. I'm ganna check compression to be sure but probably ganna get knew heads. But should I rebuild the ones I have or get new or get some off of a wrecked junker.
-
Ok well I turned the engine about 10 to 12 times by hand and my marks on the belt and the gears are different every time. Shouldn't they line back up after a few rounds.
-
Ok well I turned the engine about 10 to 12 times by hand and my marks on the belt and the gears are different every time. Shouldn't they line back up after a few rounds.
-
-
Ok all timing is correct but it still won't start. It will almost start but then it just starts turning slow again. Still has a little back fire but no flame out the breather anymore. I'm stuck.
-
Ok all timing is correct but it still won't start. It will almost start but then it just starts turning slow again. Still has a little back fire but no flame out the breather anymore. I'm stuck.
-
Ok I counted the teeth on the belt and I was 1 off on top fixed that. Now I'm ganna check the ignition timing again to see where I'm at.
-
Should the cams be hard to turn. My crank is a little tough to turn but that's normal what about the cams.
-
Should the cams be hard to turn. My crank is a little tough to turn but that's normal what about the cams.
-
Ok I do not have a way to test compression but when I try to start it with the breather off it occasionally blows a flame out the breather.
-
I just bought a 95 nissan pathfinder. It has set for 4 months. The guy said he the timing belt broke he replaced it but it would not start. I checked and the timing was not set correctly. I set it correctly but it still won't start. The engine seems to be turning slow to me. I'm getting fire and I'm pretty sure I'm getting fuel because when I pulled out a plug it smelled like gas. Can someone please help me.
-
New timing belt but won't start
-
Ok my pathfinder runs 3000 to 3500 rpm at 45 to 50 mph. I know that's to high but it seems to be shifting properly. Any ideas?
-
Jgc not Ngoc
-
And are there some shocks. Ngoc or others that will fit for the back
-
Ifs huh? Will it be wobly without the rear sway bar? I will be getting new uca in the near future but for now this is all I can do.
-
I am fixing to lift my pathfinder with jeep grand Cherokee coil springs and a reindex of my t bars.do I have to change shocks or do anything with the sway bar links?
-
Lifting and modifying my $400 pathfinder
-
If I do the deep coil springs and reindex my t bars do I need to get different shocks and do I need to do anything with the sway bar links.
-
Ok I'm trying to lift my pathfinder and I'm ganna use the jeep springs and reindex my t bars do I need to get different shocks and do I need to do anything with the sway bar links.
1995 nissan pathfinder
in 90-95 WD21 Pathfinders
Posted
The switch is off and when I turn it on it runs higher rpms