[Planning my lift on QX4]

I just went through this same thing. After hours of research I pulled the trigger. I have a97

AC springs 2"

1" strut spacer

Bilstien longer rear shocks

4" B'S. I couldn't find 3.75

285/75/16 fierce attitude tires

I added a 1.75 spacer because I thought I needed it

I had to trim metal in the front

After wheeling I rubbed my rear wheel wells

I just removed the spacer

It clears the strut by a hair

Tested the rear and no rub yet

I have yet to wheel with this set up

Manual hubs are a necessity to save CV as well as the increased mpg

 

 

Sent from my iPhone using Tapatalk

[Random picture of your R50]

Incredible pictures and video. Where is this trail.

 

 

Sent from my iPhone using Tapatalk

[Weird shuddering problem while accelerating.]

Well issue has not repeated itself

Clutch is not that old. Just replace plugs wires distributor and fuel filter. Also just put on flurey's skid plates awesome!

Going to drive it for a while and see what happens

 

 

Sent from my iPhone using Tapatalk

[What did you do to your Pathfinder today?]

Got my flurey's skid plates on

New plugs wires and distributor

 

 

Sent from my iPhone using Tapatalk

[Weird shuddering problem while accelerating.]

It is not new, so I will have it changed.

But, when it was shuddering I would put in the clutch and it would rev fine

[Jacks pass Run]

great pictures, looks like a lot of fun

[Weird shuddering problem while accelerating.]

1997 manual 3.3

Everything has been fine till the other day.

I had less than 1/4 tank of gas.

Engine was idling weird.

While accelerating in first and second truck was jerking like someone was switching the gas on and off.

In 3rd gear under very mild throttle pressure. Every thing was fine.

I filled up the tank, problem continued.

Next day I drive it 10 miles and no problems and the check engine light is not on.

Any ideas

Thanks in advance.

[Random picture of your R50]

It's beautiful in Colorado

 

 

Sent from my iPhone using Tapatalk

[Random picture of your R50]

Burr! I'm cold just looking at her. How do you like your locker?

[No truck of the month]

3 months lacking any truck of the month.

Why are there so few entries?

It seams random pictures has a lot more action.

[Random picture of your R50]

Looking nice

[Just Springs]

My .02.

If you're going in there do it right the first time. You have to compress the springs to get it on the strut.

I would recommend AC springs 2" lift and add a 1 " strut spacer. Once you lift I would definitely install locking hubs, Warn, Mile Marker or the like. Also check front ball joints, steering rack. I know it all cost money. But doing things 3 times really sucks

I have the springs and they are great. My old ones were really soggy and sucked for off roading going over rocks and slamming down.

Good luck

[What do you always have with you?]

I used on my last trip

Shovel,sockets,screwdriver,knife gps, ice scraper, blanket,gloves, camera tire deflator, compressor, hammer

[Random picture of your R50]

 

 

Sent from my iPhone using Tapatalk

[Specific tire size question!]

You can always add spacers or adapters and get the grinder out

I got 285/75/16 with 4"BS, i thought I would need spacers so I got 1.75, but that is over kill.

I need to fab a little on the wheel well

[What do you always have with you?]

Great suggestions.

I need to get going on this large list

[R50 Crosslink, Mid Skid and Rear Skid PreSale -Ends December 31st-]

Thanks fleurys.

What a great Christmas present to myself. I can't believe no one else is stepping up.

Protection is not sexy but is necessary and only a fraction more than steel.

I hope people step up and reward you for your creativeness.

Merry christmas NPORA

[R50 Crosslink, Mid Skid and Rear Skid PreSale -Ends December 31st-]

Wow looks great.

The weight savings is amazing

Cant wait to get them

[Random picture of your R50]

2. Just got new shoes, lift, basket, sliders, tint
3. Time to hit the trails
6.