- Sign In Changes: You now need to sign in using the email address associated with your account, combined with your current password. Using your display name and password is no longer supported.
- If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.
513yj
-
Posts
48 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Everything posted by 513yj
-
no spark means none, nada, zip, zilch this thing hasn't got any spark at the coil, let alone the plugs so i think there is something botched at the coil or that transistor thingamabobberdoodlehickey i don't know what the specs are for voltage but i posted what i have earlier, i looked for fusable links and don't see any at the bat or by the box on the pass fender either. probably gonna try that module if the power figures are wrong. oh yea it also is firing the injectors and the bat is fully charged . need coil power and then i can tell if the plug wires are firing too.
-
those voltage numbers are while trying to start it.
-
uh oh, there isn't one. all there is is the box before the coil, ign module? that plugs into the coil, but it might be supposed to be attached to the coil? and it might be the power transistor if it plugs into the coil. the wiring looks ok but i could be wrong. the coil high side has 10.8 volts and drops to 8.7 low is .07 and gains to .13 and that is coming out of that box (ign module?, power transistor?) if these numbers are right then i think the coil is shot, also if that box is the transistor it is not grounded out right now, should it be? any clue? none here
-
basically i'm looking for the most common thing and then go from there.
-
ok so here goes, this is my first nissan (jeeper) and i got it for nothing to bomb around in while the gas chrisis rages(drive a chevy 1 ton 10mpg) this is an 88 pathy and it had no spark when i got it. the po replaced the coil which was split. i tested it off and from the coil wire end to the terminals and get 9.76 in the 20k ohm section on my meter is this right? i have some voltage at the dist, and can't remember what it was right now but one plug in was like 11-12 and the other plug in was like 3-5. where do i start? i am lost without any manual but can't get one till tuesday. the module before the coil has power on both sides is this right? and how much should each one be if that is right? not really sure what to check and what the specs are supposed to be so any and all help would be greatly appreciated.