Jump to content

engine runs better cool or hot ,any suggestions


jaca
 Share

Recommended Posts

My pathy is 10 years old XE 5 speed manual, 200.000km.Thinking about changing

 

thermostat ,asuming might be about time. Dont know how to check if is still good ? has

 

anybody know way how to check it.? ( just thinking if this is going to help in anything

 

,cant complain about heat in low temperatures)

 

My gauge on dash showing in winter .max needle going up just bit above quorter of

 

scale.

 

And I know O2 sensor does not respond till

 

needle riches this point of temp( was waching ECU green diode).Maby this is my answer

 

for angine runnig rich til reaches normal working temp.

 

Does anybody have any comments in this subject??

 

Learned a lot about my NISSAN PATHFINDER XE from this side,THANKS GIRLS AND GUYS !!!!

Link to comment
Share on other sites

If your t'stat is bad, your pathy will overheat. they are quick to let you know. if it hasn't been changed in a while (since last t-belt change or before) it is time, as is the water pump.

pathys are only allowed 170 degree t'stats. if you run the motor hot.. you will warp the heads.. which is not good. remember.. everything but the actual block on these motors is aluminum. very sissy when it comes to excessive heat. ;)

 

as for your needle location.. yes, that is at 170 degrees/working temp.

 

another way to tell if your t'stat is bad is a jumpy temp gauges (goes hot to cold.. to med in a short period of time driving) :beer:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...