dragonfly Posted November 15, 2007 Share Posted November 15, 2007 Ok I have completed most of the repairs I plan to do for now, Heres the list Upper and Lower Ball joints OME Front, rear shocks and springs Serviced the wheel bearings when knuckle was removed Warn Hub install BFG 31x10.5 and new steel wheels The problems.Vibration I thought the alignment may be the issue or wheel balance. After reading a few threads about the Warn hubs I noticed that I need to put the snap ring back on the shaft. I did not see anywhere on the instruction where it said to do that?? I did try but the shaft would not move out far enough to get it on so I assumed it was not required. Would this also caouse a vibration?? Anybody else have this problem?? I will try again on Friday. HELP Thanks Link to comment Share on other sites More sharing options...
dragonfly Posted November 19, 2007 Author Share Posted November 19, 2007 HMMM FUN FUN FUN Discovered That the bearings on the right hand side have slight play.. I will repack and re torque. Possibly replace. This may have stemmed from my curb collision at a roundabout when we had a foot of snow last year which led to a bad rh lower ball joint..ETC RH Brake caliper is seized Very sloppy Idler arm........I need my Calmini kit Learning is interesting and stressful $$$$$ Snap rings installed on the inner groove. For the Warn Hub install Link to comment Share on other sites More sharing options...
YOTA187 Posted November 20, 2007 Share Posted November 20, 2007 Ok I have completed most of the repairs I plan to do for now, Heres the list Upper and Lower Ball joints OME Front, rear shocks and springs Serviced the wheel bearings when knuckle was removed Warn Hub install BFG 31x10.5 and new steel wheels The problems.Vibration I thought the alignment may be the issue or wheel balance. After reading a few threads about the Warn hubs I noticed that I need to put the snap ring back on the shaft. I did not see anywhere on the instruction where it said to do that?? I did try but the shaft would not move out far enough to get it on so I assumed it was not required. Would this also caouse a vibration?? Anybody else have this problem?? I will try again on Friday. HELP Thanks What kind of steel wheels did you go with, do you know what the backspacing is? I'm looking in to getting new wheels and I have the same tires on Legos right now. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now