I did this job and replaced all the gaskets and the thread in pvc valve.
Well..put it back together and went to start it up.. It starts and then dies UNLESS i give it a bit of gas as it starts up. Then it runs normal.
ANyone know the torq on the intake bolts? I did them by hand and made sure they were tight.
I did not use any gasket maker..anyone think this would help?
I did take everything apart again..then back together again and the same thing happens.
ANY IDEAS?
It's been about 1 month since last time I did it and I just have to tap the gas as it start up every time. This gets it running normal. Its been cold here and I haven't had the time to try it again with some gasket maker.
I can only think its a vacuum leak..but it's weird that it runs ok after i tap the gas at start up.
Threadlocker on Power Valve screws (pics)
in How-To's
Posted
OK.. small problem here.
I did this job and replaced all the gaskets and the thread in pvc valve.
Well..put it back together and went to start it up.. It starts and then dies UNLESS i give it a bit of gas as it starts up. Then it runs normal.
ANyone know the torq on the intake bolts? I did them by hand and made sure they were tight.
I did not use any gasket maker..anyone think this would help?
I did take everything apart again..then back together again and the same thing happens.
ANY IDEAS?
It's been about 1 month since last time I did it and I just have to tap the gas as it start up every time. This gets it running normal. Its been cold here and I haven't had the time to try it again with some gasket maker.
I can only think its a vacuum leak..but it's weird that it runs ok after i tap the gas at start up.