Jump to content
  • Sign In Changes:  You now need to sign in using the email address associated with your account, combined with your current password.  Using your display name and password is no longer supported.

 

  • If you are currently trying to register, are not receiving the validation email, and are using an Outlook, Hotmail or Yahoo domain email address, please change your email address to something other than those (or temporary email providers). These domains are known to have problems delivering emails from the community.

dannrathers

Members
 View Profile  See their activity

  • Posts

    1

  • Joined

  • Last visited

 Content Type 

Everything posted by dannrathers

  1. dannrathers
    OK.. small problem here. I did this job and replaced all the gaskets and the thread in pvc valve. Well..put it back together and went to start it up.. It starts and then dies UNLESS i give it a bit of gas as it starts up. Then it runs normal. ANyone know the torq on the intake bolts? I did them by hand and made sure they were tight. I did not use any gasket maker..anyone think this would help? I did take everything apart again..then back together again and the same thing happens. ANY IDEAS? It's been about 1 month since last time I did it and I just have to tap the gas as it start up every time. This gets it running normal. Its been cold here and I haven't had the time to try it again with some gasket maker. I can only think its a vacuum leak..but it's weird that it runs ok after i tap the gas at start up.
×
×
  • Create New...