Jump to content

Steps for 2" Lift


drew0814
 Share

Recommended Posts

I have been doing a lot of reading on what to do for a 2" lift for an R50. It seemed like the easiest way to go about this was to buy everything through 4x4parts.com. However, when I went to buy the front coils, rear coils, 2 Bilstein 5100 shocks, and a camber alignment kit. This came out to about $580. When I went to check out the shipping cost was $194. This seemed a little extreme as I am in Southern California and the parts should not weigh this much. I'll link the parts I was going to buy below here,

4x4 Parts Front Lift Coils

4x4 Parts Rear Lift Coils

Bilstein 5100 Shocks

Camber Kit

I then found a link on this forum to a set of ARB OME lift coils on Amazon. However, I could not find any of the front lift coils to pair with these. I also could not find a camber alignment kit for these. 

Any recommendations on what to do? I'm sure this dilemma has been met many times but I cannot find any clear steps on what to do. I am willing to pay for the shipping cost on 4x4parts.com but I would rather not if it is not necessary.

Thanks for everyone's help

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...