Jump to content

UPDATE - Unfortunately, the data that was lost is unrecoverable by the host.  If you joined between May 26th and Jan 13th please feel free to sign up again.  In addition, all posts and messages during that time have also been lost.  At this point there is nothing that can be done, other than to move forward from here.

 

Thank you for your patience and understanding.

-NPORA Mod Team

*Updated: 02/06/2022 5:26PM PST

Engine ID


Dragster
 Share

Recommended Posts

I have heard that the later 3.3 starters will fit, and have a different design. Could be that. I would just go on Rockauto and pull up a picture of a 3.0 starter, and a 3.3 R50 starter, and see if one of them looks like what you've got.

Link to comment
Share on other sites

I have only ever seen one starter on the wd21 v6 pathy. Auto parts store people tend to be stupid...Sorry for the weird picture sizes but this may help. I would think any of them would fit since the blocks are the same and you can interchange the flywheels between them.

 

This is what it should look like:

17196N_B1.jpg

 

 

If it is out of a newer (3.3L) it will look like this:

17236_ANG.jpg

Edited by adamzan
  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

Welcome to NPORA Forums

 

Please register to gain full access to the forum.

Make sure you read the Forum Guidelines and don't forget to post a new intro in the New People Start Here! section, to say hi too everyone.

 

-NPORA

×
×
  • Create New...