Jump to content

Due to a hardware failure on the hosts systems, all posts and messages created between May 26th and Jan 13th have been lost. Additionally, if you joined the NPORA Forums community during that time, you'll need to re-register. -NPORA Mod Team *Updated: 05/19/2022 12:15AM PST

Upper Control Poly Bushings


Trogdor636
 Share

Recommended Posts

What's up party people? Been forever since I've been here....

 

I'm installing UCA poly bushings with no good instructions....should the outer lip of the bushing be on the outside of the UCA on both sides? Or should it look as if you used the press in bushings....anybody have a good picture of theirs? Thanks!

Link to comment
Share on other sites

http://www.nicoclub.com/archives/nissan-hardbody-truck-suspension-torsion-bars-bushings.html

 

It's for a 2wd but the uca are the same.

 

You do want the flange part on the outside on both sides. It's fairly easy, I was able to push in my poly bushings by hand. Make sure to use a grease made for it or you'll be replacing them again in a short period of time.

  • Like 1
Link to comment
Share on other sites

Thanks guys, that helped. It seemed like the proper way, Prothane sent me instructions for a leaf spring.....

 

I did use a ton of their "super grease" I know how noisy my sway bar bushings get....Thanks again.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

Welcome to NPORA Forums

 

Please register to gain full access to the forum.

Make sure you read the Forum Guidelines and don't forget to post a new intro in the New People Start Here! section, to say hi too everyone.

 

-NPORA

×
×
  • Create New...