Jump to content

Due to a hardware failure on the hosts systems, all posts and messages created between May 26th and Jan 13th have been lost. Additionally, if you joined the NPORA Forums community during that time, you'll need to re-register. -NPORA Mod Team *Updated: 05/19/2022 12:15AM PST

anyone cut the roof off?


Recommended Posts

  • 2 weeks later...
  • 2 weeks later...
  • 4 months later...

Just a lil update for ya. were almost done with the cage. square tube is 2"x4" .120 wall steel, and the halo is 2" .095 wall. the cross bars and stuff will all be 1.5" .095. were cutting out a rag top for it now, cuz march 10th were taking it to the dunes for some sand time :)

 

0215110942.jpg

Link to comment
Share on other sites

  • 2 weeks later...

Just a lil update for ya. were almost done with the cage. square tube is 2"x4" .120 wall steel, and the halo is 2" .095 wall. the cross bars and stuff will all be 1.5" .095. were cutting out a rag top for it now, cuz march 10th were taking it to the dunes for some sand time :)

 

0215110942.jpg

 

I pray to god you don't even drive that on the roads, from what i can see, the welds on the "cage" look like a pigeon took a @!*% where you put two peices of metal together, i mean for gods sake at least run it down to the floor, plate it, and than take it to the frame with a butt peice on the other side

Link to comment
Share on other sites

Didn't you say this in the other thread?? Once is enough, no??

 

Seriously, next time try to say your point in such a manner that it is informing and considered, not insulting and rejected.

 

Thanks,

 

B

Link to comment
Share on other sites

  • 9 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

Welcome to NPORA Forums

 

Please register to gain full access to the forum.

Make sure you read the Forum Guidelines and don't forget to post a new intro in the New People Start Here! section, to say hi too everyone.

 

-NPORA

×
×
  • Create New...