[Max tire size on full stock]

I ran 265 70 r17s with 0 offset wheels on my 04 before i lifted it. Had to trim just a touch of the inner fender. If you're running stock rims you probably won't even have to do that

[What did you do to your Pathfinder today?]

FINALLY!!! Managed to get some serious work done on my custom low profile winch bumper!! Happy will the result. Now I have to bend some tubes for the corners and finish the front skid plate AND paint it! (And fix my very messy wiring haha)

Sent from my SM-A520W using Tapatalk

[Random picture of your R50]

Finally finished welding up my low profile winch bumper last week!

Sent from my SM-A520W using Tapatalk

[Dual battery setup]

I had 2 at one point. I turned the original 90*, moved the fuse box a tiny bit back, removed the battery clamp, slid the original as far as i could to the passenger side, then fit the second one beside it. Had to extend the ground cable. 

Thank you! I would love a picture, if you have one!

Sent from my SM-A520W using Tapatalk

[Dual battery setup]

I'm looking to do a dual battery set up on my 2004 pathfinder. I wonder if anyone here has done it and how they positioned the batteries. Photos would be appreciated!

 

Sent from my SM-A520W using Tapatalk

 

 

[Remote car starter recommendations]

Baby #1 is on the way and as I live in northern Canada a remote car starter is a must for the Pathy. Does anyone have any recommendations for a remote car starter for an 04 3.5L with a manual transmission?

Thanks!

 

Sent from my SM-A520W using Tapatalk

[Random picture of your R50]

It goes in the trailer hitch. Made by HitchGate I believe.

Much appreciated

 

Sent from my SM-A520W using Tapatalk

[Random picture of your R50]

Merry Christmas!

 

Sent from my SM-A520W using Tapatalk

[Random picture of your R50]

POPICS by gspeed151,

23905716_10156021899564165_5710794748786344783_n by gspeed151,

How'd you get a swing gate on the stock rear bump?

 

Sent from my SM-A520W using Tapatalk

[Picked Up and OEM Hitch]

What IS the R50 rated to tow?

 

Sent from my SM-G870W using Tapatalk

[I've got a P0021 OBD Trouble Code HELP]

Driving home after a bad few days and my 04 R50 start acting up! No top end power at all! I pull over and I can feel the engine is a little off balance. I ran the codes and I got a (cam shaft position over advanced) code. Could this be a sensor or did my timing belt skip?

 

Sent from my SM-G870W using Tapatalk

[Quick question]

I'm not at home right now but I'm pretty sure the socket needed it a 22mm. The thread size and pitch I do not know..

 

 

Sent from my iPhone using Tapatalk

Thanks!

 

Sent from my SM-G870W using Tapatalk

[Quick question]

This is a long shot but can anyone tell me what size the banjo fitting is for the power steering return coming off the steering rack?

 

Sent from my SM-G870W using Tapatalk

[Nissan Pathfinder 1996 front wheel hub]

Those rings are a huge pain! I strongly recommend getting a universal angle grinder bolt wrench, works like a dream on those rings

 

Sent from my SM-G870W using Tapatalk

[VQ35 excess oil consumption - Is it terminal?]

All the research I've done points to the crappy piston rings that nissan put in an otherwise amazing engine

 

Sent from my SM-G870W using Tapatalk

[VQ35 excess oil consumption - Is it terminal?]

I have a 2004 se r50 with a 5 speed. It's done the exact same thing since I bought it over 3 years ago. I bought it knowing about the oil consumption at 170, 000 km because I was planning an engine build for it. It now has almost 270, 000. I drive it hard with over sized tires and it has seen 4 canadian mountain winters. since I have the new engine ready to go and need an excuse to do the swap, I've even stopped topping it off (except before road trips). Still runs like a champ! The thing can't be killed!

 

Sent from my SM-G870W using Tapatalk

[Auto locking hubs?]

Does anyone know of a way to put auto locking hubs on the front of a R50? I'm gonna order a set of the warn manual hub unless anyone has a better idea.

Thanks

 

Sent from my SM-G870W using Tapatalk

[Stock Bumper Winch Mount]

Holy that's some serious steel for those mounts. I've been working on my own custom low profile tube winch bumper. (Progress has been slow) I was worried if my design was strong enough but thanks to an altima that ran a red yesterday, I'm not longer worried lol 5000$ in damage to her and my pathy and bumper totally unharmed

 

Sent from my SM-G870W using Tapatalk

[High Idle after TB cleaning]

How long did you leave the battery unhooked?

 

Sent from my SM-G870W using Tapatalk

[2001 Pathy idle issue]

I had similar problem with my idle speed. before you start thinking your ECM is fried try resetting it, simplest way to do this is leave the battery unhooked for 48 hours. Worked for me

 

Sent from my SM-G870W using Tapatalk

[How-To: R50 Rear Disc Brake Conversion]

Thanks so much! My pathy's rears need replacing and I'm going to try tackling this in the next month

 

Sent from my SM-G870W using Tapatalk

[Trouble with trouble code]

Much appreciated

 

Sent from my SM-G870W using Tapatalk

[What did you do to your Pathfinder today?]

Guess I should've probably read the whole post first lol

 

Sent from my SM-G870W using Tapatalk

[What did you do to your Pathfinder today?]

New exhaust!!! New Y pipe then a 1-1 flowmaster 40 2" out to a 2.5" tip in stock location. Sounds like a rumbley little 350Z now. Not too much drone or cackle just a nice low growl until you crack Into It and it gets good and loud.

Are you getting any exhaust drone? I had a similar setup in my 2000 maxima with the 3.0 back in the day and it had some low rpm drone

 

Sent from my SM-G870W using Tapatalk

[What did you do to your Pathfinder today?]

Hey Hawairish, did you do a rear disc brake conversation on your R50? If so I would love any info you have on it! Please PM me if you don't mind

 

Sent from my SM-G870W using Tapatalk