SellOut

Painted it in the garage about 2 years ago the color is "destroyer gray" if I remember right Sent from my HTC6535LVW using Tapatalk

I believe they were a little bigger.. not super sure on that but I had to trim the front bumper a little Sent from my HTC6535LVW using Tapatalk

I had a 2.5" front 2" rear leveling kit from supreme suspension and 2" hub centric wheel spacers on stock le wheels (the last is a before and after pic) Sent from my HTC6535LVW using Tapatalk

Is it just me or do you guys think that the r50s have almost a 50/50 shot of understeering vs oversteering? I messed up my pathy yesterday​ and I'm wondering if I'm just bad driver or if it's more common than I'm thinking... (Everyone in the car left without a scratch) Sent from my HTC6535LVW using Tapatalk

If I go up to 35's would I have to regear? If so what ratio would be best? I do less than 200 miles a month on the freeway so I'm not too worried about my top speed being over 75(as long as I'm not going 65 at 4k rpm) Sent from my HTC6535LVW using Tapatalk

If I go up to 35's would I have to regear? If so what ratio would be best? I do less than 200 miles a month on the freeway so I'm not too worried about my top speed being over 75(as long as I'm not going 65 at 4k rpm) Sent from my HTC6535LVW using Tapatalk

I haven't used a roof top tent but I did put a piece of plywood on my roof rack and slept on that before (don't ask) it was fine for me though (I weight 145lbs) Sent from my HTC6535LVW using Tapatalk

Before you guys get too excited I haven't put much thought into it yet, but what do you think of fabricating a frame out of 2x4 .25 wall, essentially taking a Jeep jk or cj suspension design and throwing that on to the frame, then bolting/ welding the whole thing on the bottom of a r50? I know it would take quite a long time but I'm looking for a summer project... Is it possible to do and could I still daily drive it? Sent from my HTC6535LVW using Tapatalk

Before you guys get too excited I haven't put much thought into it yet, but what do you think of fabricating a frame out of 2x4 .25 wall, essentially taking a Jeep jk or cj suspension design and throwing that on to the frame, then bolting/ welding the whole thing on the bottom of a r50? I know it would take quite a long time but I'm looking for a summer project... Is it possible to do and could I still daily drive it? Sent from my HTC6535LVW using Tapatalk

31" just a guess but you may need some wheel spacers... I got all 4 spacers for $100 on eBay... 6x5.5 lug pattern and I got mine in 2" Sent from my HTC6535LVW using Tapatalk

Not a brand it just refers to the type of lift Sent from my HTC6535LVW using Tapatalk

Sent from my HTC6535LVW using Tapatalk

Like slartibartfast said, drill a hole close to your maf and I'd just put a zip tie on both sides of it to "clamp" it onto the tube Sent from my HTC6535LVW using Tapatalk

Have you already put it on? Sent from my HTC6535LVW using Tapatalk

So I was going through some pretty rough terrain and ended up getting water and mud in my ignition coils... anyways has this happened to anyone else or is it just that my pathy is special? Thanks for any replies!