Jump to content

Turn Signal Not Returning to Neutral Position


Recommended Posts

So as title states, I am having an intermittent issue with my turn signal. My right side stalk will work. But will not return to a neutral state once the turn is completed. It doesn't happen on right turns only. Doesn't matter how little or how big the turn is, it doesn't return to neutral.

I removed the stalk to check for damage but I didn't find anything wrong with the tabs that actually trigger the switch off. Any thoughts or ideas? Thanks!

Link to comment
Share on other sites

Have you had a wheel alignment recently? 
If the steering wheel has been re-fitted off-centre (bad alignment shops often cause this) the wheel may need close to a full-turn to hit the detents on the switch.

Also - make sure the two roll pins are in place on the bottom of the steering wheel. 

Link to comment
Share on other sites

I have a similar problem with mine, though it is the left cancel that is not reliable. In my case I believe it is wear on the tabs on the steering wheel and the switch. With mine, it got worse when I replaced the steering wheel. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...