Jump to content

manual trans removal question


gixxaben
 Share

Recommended Posts

hows it goin guys and girls

am in the middle of removing the transmission

as the thrust/throw out bearing is makin a whole lot of noise

now iv got all trans separated from the block but it still in place cos of the input shaft and now the

transfer case is now fouling the torsion bars mount

problem is, did i have to take off the mount that holds the torsion bars

and transfer case off aswel

ive taken off the gearbo mount and thought it would be enough

but theres no more room to slide the whole unit out doe to the torsion/transfer case mount in the frickn way

any tips would be greatly appreicated

cheers Ben

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...