Nefarious

Nissan Y U NO keep the same taper?

picked up my wire lock pins for 4.49 for all 4. detachable rear seat mod tonight. getting ready for camping!

Hmm..any way to make an R50 overhead console work in a WD21? Or am i just dreaming again...

Hmm..any way to make an R50 overhead console work in a WD21? Or am i just dreaming again...

Finally fixed the hinge bushings in my spare tire carrier. Wow what a pain.. upper hinge pin was easy, bottom one took some serious help to get out. Got er all done and no more rattle going over bumps!! Finally opens and closes properly too. It even opens itself once the latch is released! So cool ...

Jacked up the truck with correct alignment. Still out of caster but whatever it drives straight and I'm not in the mood to shim those tension rods. I'll just wait until they wear again. lol

Jacked up the truck with correct alignment. Still out of caster but whatever it drives straight and I'm not in the mood to shim those tension rods. I'll just wait until they wear again. lol

Well, its been fun all. Baby # 3 on the way, had to sell my pathy's, got me a new diesel quad cab p/u. Thanx for all the great info and people I met while being here. Cheers.

Jacked up the truck with correct alignment. Still out of caster but whatever it drives straight and I'm not in the mood to shim those tension rods. I'll just wait until they wear again. lol

E-fan swap complete. Much more power and engine bay room!!

What time is it? It's time to go wheeling!

Woo-Hoo! Going to pick up my E-fan today!

About to go pick up the truck from the shop. Hopefully my steering project wasn't a failure.

Woo-Hoo! Going to pick up my E-fan today!

E-Fan Swap? Definitely.

E-Fan Swap? Definitely.

Just picked up a Lincoln Weld-Pak 180HD MIG/flux core combo. Can't wait to do some real burning!

Just picked up a Lincoln Weld-Pak 180HD MIG/flux core combo. Can't wait to do some real burning!

Welded up some proper exhaust hangers for my custom 2.5 inch exhaust today. Now it's in there nice and tight. Also welded up the floor of my sisters Chevette.... one of the front seat bolts tore off bringing a 3x3 piece of sheet metal with it...sigh....

Welded up some proper exhaust hangers for my custom 2.5 inch exhaust today. Now it's in there nice and tight. Also welded up the floor of my sisters Chevette.... one of the front seat bolts tore off bringing a 3x3 piece of sheet metal with it...sigh....

Okay... rear of frame modified to move rear steel bumper up 3" to match body lift... Front r50 light guard started cutting apart to make it fit the wd21.. this is gunna look good... straightened the pigtails on some JGC springs.... this is going to be a seriously productive weekend.

ordered my 2wd hardbody swap parts today for a grand total of 105$ after shipping for inner tie rods and center link. just need to hit the junkyard for some sacrificial pathy adjustment sleeves.

man 16$ for ultra low profile bump stops made a huge difference in my ride. i have down travel again! woo! smoothed out the ride huge on the road.. just some balljoint spacers and upper control arms and i might have some real front flex!

Installed the oem steering damper pin from Nissan 19$ and used a Monroe shock for 55$ and Lordco hardware for 3$... Grand total of 77$ and wow... Truck feels so much better driving down the road with 33x12.5 and 15x10 steel rims.. Almost feels like a fullsize now haha!

Going to put NOS in my Pathfinder.