Jump to content

NPORA Staff email addresses have been restored for over two weeks now and most have updated and accessed by individual staff.  If you have tried to contact a staff member by email and they have not responded please make a second attempt using the forums Private Message system. If that is also unsuccessful please reach out to another member of the staff.

Solid Axle Swaps, Hardcore Custom Fab

This is the place to post about your SAS or any custom fabrication you've done to any Pathy.

245 topics in this forum

    • 415 replies
    • 50,110 views
    • 8 replies
    • 748 views
    • 83 replies
    • 10,126 views
    • 1 reply
    • 346 views
  1. Ammo Can Console

    • 19 replies
    • 2,071 views
  2. New rear bumper 1 2

    • 34 replies
    • 3,022 views
    • 90 replies
    • 18,232 views
    • 7 replies
    • 401 views
    • 3 replies
    • 443 views
  3. 1UZFE VVTI in an R50

    • 0 replies
    • 241 views
    • 59 replies
    • 14,113 views
    • 2 replies
    • 1,106 views
  4. R50 half door build

    • 23 replies
    • 2,890 views
    • 8 replies
    • 905 views
    • 156 replies
    • 16,212 views
    • 197 replies
    • 16,619 views
  5. SAS with hpd44

    • 10 replies
    • 1,298 views
    • 14 replies
    • 981 views
  6. Fabbing a new frame

    • 0 replies
    • 444 views
  7. RB25 SWAP

    • 5 replies
    • 1,189 views

Welcome to NPORA Forums

 

Please REGISTER to gain full access to the forum.

Make sure you read the Forum Guidelines and don't forget to post a new intro in the New People Start Here! section, to say hi too everyone.

 

-NPORA

×
×
  • Create New...